Creating routes

Creating routes involves automatically generating routes in a linear coordinate system based on selected object types.

The process entails automatically adding calibration points to routes based on point objects located on them, with semantic values corresponding to linear coordinates. The code of the processed semantics is defined in the Service Parameters section of the Map Editor.

Multiple types of linear and point objects located on different maps added to the document can be processed simultaneously. All types of linear objects must be located on the same map, and all types of point objects must also be on the same map. Point and linear objects can be located on two different maps.

After activating the mode, you should specify the object types participating in the processing by selecting the corresponding objects on the map.

When selecting an object on the map, all objects of the specified type are highlighted. Selecting the same type of object again cancels the highlighting of that type.

If multiple maps are open in the document, after selecting the first object, only objects located on the same map will be selected.

Once you have finished selecting the object types, press Ctrl+Enter to activate the route construction process.