Installation and deleting the program

For installation of the program it is necessary:

-  to set an install disk or CD-ROM;

-  to execute SETUP.EXE command;

-  to follow instructions of the setup.

In the catalogue chosen for installation of the program the following subdirectories will be created:

DB - contains files of transformation of XML data necessary for reading a file of conformity.

Example500 - an example of a large-scale map of scale 1 : 500

WINKEY - contains the install complete set of drivers of hardware keys;

Work2000 - contains a set of files necessary for converting plans of scale 1 : 2 000;

Work500 - contains a set of files necessary for converting plans of scale 1 : 500;

Work5000 - contains a set of files necessary for converting plans of scale 1 : 5 000;

Into the Start menu the labels of starting the program of converting, of starting the program of uninstalling and the labels of help system are placed.

At purchase of the program «Converter of large-scale plans into DXF format» you, except for the software, receive an electronic key of protection which is connected to parallel or USB port of a computer (the order of connection and the service regulation of an electronic key look below).

Functioning of the program is possible only on that computer to which the electronic key is connected, therefore before the beginning of work you must connect an electronic key.

For deleting the program of converting from your computer it is necessary to choose the corresponding item in Start menu.