Create object by sample |
Object creation by sample is carried out in the following order: - to activate the mode; - to choose object on 3D-model, defining type of created object; - to put an object contour onto 3D-model; - to complete object drawing by double-clicking the left mouse button.
When drawing objects of point type, the object is recorded into a map after drawing one point. When drawing objects of vector type, the object is recorded into a map after drawing the second point. At object creation the three-dimensional metrics is formed. Usually into the third coordinate the absolute height of the point lying on a surface of model is recorded. For change of the third coordinate it is necessary to use buttons PageUp and PageDown or a ruler the Lifting of mark in the Left panel. Hotkeys: Enter or the left mouse button - point adding; Escape or Backspace - deleting an extreme point; Ctrl+Enter or Ctrl + left mouse button - the completion of drawing an object; Ctrl + right mouse button - cancellation of object creating; PageUp - lift point height upwards; PageDown - lower point height downwards; L - contour closing. It is carried out only when drawing the linear objects. When drawing contour on a map in the Bottom panel the total length of created contour and length of last piece in meters on the ground is displayed. |