Create object

Print Previous page Top page Next page

ici_358 Object creation is carried out in a following order:

- to activate the mode;

- in the dialog to choose type of created object;

- to put the object contour onto 3D-model;

- to complete the object drawing by double-clicking the left mouse button.

 

At drawing objects of point type, the object is recorded into a map after drawing one point. At drawing objects of vector type, the object is recorded into a map after drawing the second point.

At object creation the three-dimensional metrics is formed. Usually into the third coordinate the absolute height of the point lying on a surface of model is recorded. For change of the third coordinate it is necessary to use buttons PageUp and PageDown or a ruler the Lifting of mark in the Left panel.

Hotkeys:

Enter or the left mouse button - point adding;

Escape or Backspace - deleting an extreme point;

Ctrl+Enter or Ctrl + left mouse button - the completion of drawing an object;

Ctrl + right mouse button - cancellation of object creating;

PageUp - lift point height upwards;

PageDown - lower point height downwards;

L - contour closing. It is carried out only at drawing the linear objects.

When drawing contour on a map in the Bottom panel the total length of created contour and length of last piece in meters on the ground is displayed.