Object dimensions check

The verification of the inclusion of objects within the boundary of the corresponding map sheet is being carried out. Such an error may occur on one of the sheets of a multi-sheet map.

If an object is found to be located outside the dimensions of the sheet, the following steps should be taken:

1. In the map editor, open the «Map Editor options» dialog and on the «Common parameters» tab, set the parameter «Trim the objects along the sheet frame».

2. In the «Measurements and results of check - Viewing results of check» dialog, locate the object on the map and select it.

3. Copy the selected object: choose the mode «Object Creation - Object Copy Creation» and save the copy (Ctrl + Enter).

4. Select the erroneous object again (as per step 2) and delete it.